When ordering pans in packs of 10, you will receive a discounted rate.

Blades come in a pack of 4 blades.

Yes, universal pans are offered in the most popular sizes.

We offer the Safety Clip and Clip-On options.

11 gauge steel

If you are needing assistance with your Hatz engine, please contact our product support team via phone or email or visit your local authorized Hatz dealer for assistance. 

Check the seat switch or spray fuse.

1. For current models, look on the website under the products tab and then search for the model. <br />
2. For older models, check trowel literature.

1. Make sure the hydraulic fuel tank is full. <br />
2. Check all hydraulic filters.

1. Make sure the hydraulic fluid tank is full. <br />
2. Check inline fuel filter. <br />
3. Check for a bad pan on the rotors. <br />
4. Check hydraulic filters. <br />
5. Make sure blades are flat and not pitched. <br />
6. Make sure the throttle lever is in full throttle position.

1. Check for worn blades. <br />
2. Check for bent trowel arms. <br />
3. Check for a bent main shaft on the gearbox. <br />
4. Check trowel arm lift levers with a proper jig.

Let foot off of the spray switch.

Check the diaphragm on top of the pump and make sure it has 50 psi 

Put both the suction and bypass hose into a 5-gallon bucket full of warm soapy water and let it run for roughly 5 minutes. After doing this, run it again with another 5-gallon bucket full of water.

Make sure the lines are clear of debris

No, only nonflammable liquids. 30% solids on 7560 and 35% solids on the 9910

Check the ¾” adjusting nut on the positive pitch clutch.

1. Make sure you have the correct belt.

2. Check belt alignment.

Make sure the set screws in the collar bushing are catching the intentions on the shaft.

1. Check belt alignment.

2. Check engine idle.

Look for a bent arm or trowel arm out of alignment.

Yes, we offer replacement springs and weights per model. Please refer to the respected parts manual.